Lesson 5 of 12 / Nutrition and transport in plants
Measuring photosynthesis
What would make a pondweed comparison fair?
I can plan and interpret investigations of light, carbon dioxide or temperature using oxygen output as a rate indicator.
I can investigate light, CO2 and temperature effects on photosynthetic rate.Syllabus
Syllabus K325, Topic 10(h). Investigate light, CO2 and temperature effects on photosynthetic rate.
About 6 min
Make a guess. You are not marked.
You move a lamp closer to some pondweed and it gives off more bubbles. Can you be sure light caused the change?
Show the answer
The lamp may also have warmed the water.
A close lamp raises temperature as well as light. Control or measure temperature before blaming light.
The key idea
Change one factor, control the others and measure oxygen output over a fixed time. Repeated measurements make the comparison more reliable.
- Change
- Change measured light intensity or lamp distance.
- Keep comparable
- Keep temperature, CO2 availability, plant amount and timing comparable.
| Condition | Volume (cm3) | Rate (cm3/min) |
|---|---|---|
| Low light | 2 | 1 |
| Medium light | 4 | 2 |
| Higher light | 6 | 3 |
A closer lamp may warm the water. Use temperature control and allow adjustment before measuring. Divide volume by 2 minutes to obtain the rates shown.
Green: aquatic plant. White gas in the inverted tube: collected oxygen. This schematic omits support stands. Bubble sizes vary; oxygen volume per time is generally a better measure than bubble count, and dissolved/respired oxygen is not collected.
Explanation
A submerged aquatic plant can release oxygen during photosynthesis. Collecting the gas and measuring its volume per unit time provides an estimate of photosynthetic activity. Counting bubbles is simpler but less precise because bubble sizes can differ. Some oxygen dissolves or is used in respiration, so the output is not a perfect measure of total photosynthesis.
To investigate light, vary lamp distance or measured light intensity. Keep temperature and carbon dioxide availability constant, and use comparable plant material and the same measurement time. A lamp can also warm the water, so a heat shield or controlled water bath helps separate light from temperature effects.
To investigate carbon dioxide availability, use comparable bicarbonate solutions while holding light and temperature constant. To investigate temperature, use controlled water baths while keeping light and carbon dioxide availability comparable. Allow the plant time to adjust before measuring each condition.
Repeat measurements, calculate a mean and look for anomalous results. A rate is quantity divided by time, such as cubic centimetres of oxygen per minute. Compare rates under the changed condition before explaining the pattern using photosynthesis and possible limiting factors.
Step by step
- 1
Design the comparison
Choose light, CO2 or temperature and state how the other two are controlled.
- 2
Measure a rate
Collect oxygen volume over a known time; repeat under comparable conditions.
- 3
Interpret with limits
Use the data trend, noting bubble-size differences or oxygen dissolution where relevant.
Worked example
Convert output to rate
In an illustrative experiment, 6.0 cm3 of oxygen is collected in 3 minutes. Calculate the rate and state one reason it estimates rather than directly measures total photosynthesis.
One way to explain it
The measured oxygen-output rate is 6.0 / 3 = 2.0 cm3 per minute. Some oxygen may dissolve in the water or be used in respiration rather than collected.
Why this answer works
- Divide volume by time.
- Include rate units.
- Link the limitation to the measured output rather than dismissing the experiment.
Watch out for this
A student says: "Moving a lamp closer changes only light intensity." What is wrong with this?
Show the answer
It can also increase temperature. A fair test must control or monitor this additional change.
Check your understanding
Why is oxygen volume usually a better measure than bubble count?
Show the answer
Bubbles can differ in size, so equal counts need not represent equal gas volumes.
Measuring volume accounts for size differences, although other practical limitations remain.
Exam-style questions
Check your understanding
Hydrogencarbonate indicator is red at normal carbon dioxide levels, yellow when carbon dioxide is higher and purple when it is lower. A leaf in bright light turns the indicator purple. Why?
Show the answer
Photosynthesis takes in carbon dioxide faster than respiration releases it
In bright light the net uptake of carbon dioxide lowers its level, so the indicator turns purple.
Quick recall
What would make a pondweed comparison fair?